ùISO8859-1:„¿Üô)8.P#“K·ù>ý  5' F n  š" ¹ , Ü 2 $ < . a  ' ® Ö ê( 0 1& b, ‰! ¶ Ø ò  " C Z* u:  6 ÛA  / T!6 „"7 »#D ó$=8%1v& ¨'@É(@ )DK*+F‘,IØ-O".Qr/;Ä0@1=A273;·42ó52&6DY7%ž8%Ä9ê::ý;Y8<5’=WÈ>A Loop mode testing will consist of error log analysis only.Adapter Configuration Error.Adapter Hardware Error.SCSI Device Error.EEH Reset Error.EEH Event Error.PCI Bus Error.Register Timeout Error.%1$06.6lx ADDITIONAL INFORMATION FOR %2$s IN LOCATION %3$s An adapter configuration error has been detected. This may indicate an invalid configuration. Ensure there are not too many devices attached. Try disconnecting and reconnecting any attached cables. Check and verify correct SCSI configuration.%1$06.6lx ADDITIONAL INFORMATION FOR %2$s IN LOCATION %3$s Analysis of the error log indicates a microcode problem. Ensure the microcode is the latest version available. If microcode is already the latest version and the problem persists, contact your local service support.%1$06.6lx ADDITIONAL INFOR0MATION FOR %2$s IN LOCATION %3$s No trouble was found. However, resource %4$s could not be restored to its initial defined state. If you do not want the device to remain in the available state, run the following command from the command line: rmdev -l %5$s -Rd%1$06.6lx ADDITIONAL INFORMATION FOR %2$s IN LOCATION %3$s An adapter configuration error has been detected for bus number %4$d, id %5$d. This may indicate an invalid configuration. Ensure there are not too many devices attached. Try disconnecting and reconnecting any attached cables. Check and verify correct SCSI configuration.%1$06.6lx ADDITIONAL INFORMATION FOR %2$s IN LOCATION %3$s An adapter configuration error has been detected. This may indicate an invalid configuration. Try disconnecting and reconnecting any attached cables. Check and verify correct configuration.Adapter Configuration Error.Permanent adapter failure.Adapter failure.Adapter device bus configuration error.Adapter failure.Temporary adapter failure.PCI bus error detected by EEH.PCI bus error detected by adapter.Temporary PCI bus error detected by adapter.Device bus termination power lost or not detected.Adapter detected device bus failure.Temporary adapter detected device bus failure.Device bus interface problem.Temporary device bus interface problem.Disk drive problem.Identify disk to be replaced.Disk returned wrong response to adapter.Addressed device failed to respond to selection.Storage subsystem configuration error.Adapter detected device bus interface error.Adapter timed out a disk command.Disk bus interface error.Temporary disk bus error.Temporary disk error.Disk detected recoverable error.Disk media format bad.Temporary disk data error.Out of alternate sectors for disk storage.Cache data associated with attached disks cannot be found.Cache data belongs to disks other than those attached.RAID controller resources not available due to previous problems.Disk has been modified after last known status.Incorrect disk configuration change has been detected.Cache data exists for one or more missing/failed disks.Controller does not support function expected for one or more disks.Required cache data can not be located for one or more disks.Cache data exists for one or more modified disks.Disk requires Format before use.Controller detected device error during configuration discovery.Controller detected device error during internal media recovery.Incompatible disk installed at degraded disk location in Disk Array.One or more Disk Array members are not at required physical locations.Physical location of Disk Array members conflict with another Disk Array.Previously degraded disk in Disk Array not found at required physical location.Disk Array is or would become degraded and parity data is out of synchronization.Maximum number of functional Disk Arrays has been exceeded.Maximum number of functional Disk Array disks has been exceeded.One or more disk pairs are missing from a RAID-10 Disk Array.One or more disks are missing from a RAID-0 Disk Array.Maximum number of functional Disk Arrays has been exceeded.Automatic reconstruction initiated for Disk Array.Disk Array is degraded due to missing/failed disk.Background Disk Array parity checking detected and corrected errors.Impending Cache Battery Pack failure.Permanent Cache Battery Pack failure.Cache Battery PackMultiple controllers connected in an invalid configurationMultiple controllers not capable of similar functions or controlling same set of devicesDisk Array is degraded due to missing or failed disk.Background Disk Array parity checking detected and corrected errors on specified disk.Two or more disks are missing from a RAID-5 or RAID 6 Disk Array.