ùISO8859-1ÕÄ2šÍß ™þ̘—eÌýûÊòÆŠ¹D J ` Í «Y yŽ Óv bv ÙIPINSTALL MICROCODE %1$s The microcode can be installed onto multiple slots on the adapter. The available slots are listed below with the current level shown in brackets. Select one slot to install microcode onto.Move the cursor for selection, then press 'Enter'.Slot %1$d :[%2$s]INSTALL MICROCODE %1$s %2$sInstallation of the microcode has not completed successfully. A software error occurred. Contact the service support structure for further assistance. Installation of he microcode has not completed successfully. The current microcode level on %1$s is still %2$s. A software error occurred. Contact the service support structure for further assisstance. Installation of the microcode has not completed successfully. A hardware error occurred. Contact the service support structure for futher assistance. Installation of the microcode has not completed successfully. The current microcode level on %1$s is still %2$s. A hardware error occurred. Contact the service support structure for futher assistance. Installation of the microcode has not completed successfully. An error was detected while configuring the following resource: %1$s Please run diagnostics on all of the following resources to ensure that the adapter is functioning properly: %1$s Installation of the microcode has completed successfully on the following instances of the adapter: %1$s The current microcode level is %2$s. Please run diagnostics on these resources to ensure that the adapter is functioning properly. Installation of the microcode has completed successfully on the following instances of the adapter: %1$s The current microcode level is %2$s. However, an error was detected while restoring the adapter to its initial state. An error was detected for the following resource: %1$s Please run diagnostics on the following resource to ensure that the adapter is functioning properly %1$s Installation of the microcode has completed successfully on the following instance of the adapter: %1$s The current microcode level is %2$s. However, the Configuration Data Base was not properly updated for the following resource: %1$s. To properly update the Configuration Data Base, please run: rmdev -l resource -R (for each resource listed) followed by: cfgmgr -l resource (for each resource listed) Until this is done, neither lscfg nor the Display Microcode Task will reflect the correct microcode information. Installation of the microcode has not completed successfully on the following instance of the adapter: %1$s - Slot %2%d Microcode levels may differ in one or more firmware slots now. Please run diagnostics on the following resource to ensure the adapter is functioning properly before attempting to download microcode again. Installation of the microcode has not completed successfully. The current microcode level on %1$s is still %2$s. A software error occurred. Contact the service support structure for further assisstance. A software error occurred. Contact the service support structure for further assistance. A hardware error occurred. The adapter did not successfully process a request. Contact the service support structure for further assistance. A software error occurred. Unable to configure adapter. Contact the service support structure for further assistance. A software error occurred. Unable to configure adapter. Contact the service support structure for further assistance. Warning: One or more firmware slots are not at the same firmware level.