ISO8859-1+H t / :ASW4A?v:     ! +5= F%:S*3+#,.]/3\0V1Q2F93X4S8 -;' M% u$  2 , ( @ i +  $  ! 9$ [ * % '   1 Q_ ln k;SDF@ ALTERNATE ATM MAC address (12 hex digits)Minimum Guaranteed VCs SupportedMaximum Number of VCs NeededATM AdapterTrace an ATM AdapterList All ATM AdaptersChange / Show Characteristics of an ATM AdapterEnable ALTERNATE ATM MAC addressno,yesIf yes, will use the user defined MAC address rather than the address found in the read only memory of the adapter. This is most useful when changing the card on which an ARP server was running.The alternate MAC address for the adapter; to be used in place of the address found in the read only memory of the adapter; eg. 0x0123456789abThe minumum number of VCs that the system is guaranteed to accomodate at any time.The maximum number of VCs that the system is expected to accomodate at any given time.Error: Alternate MAC address must be 12 hex digits. Error: Alternate MAC address can not be removed while enabled. Error: Specify an alternate MAC address when enabling it. metric %d inet %s netmask 0x%x broadcast %s arpaddr idle %d ns %s iso %s netmask %s Error: enter a 12 character hex address: eg. 0123456789ab Enter a 12 character hex address: eg. 0123456789ab Attribute not changable with chdev Best peak rate changed You have choosen a non-default PDU size. Please realize that the buffer size and MTU values should usually be equal and tuned to your traffic; performance degradation can occur if these values are either too large or too small. ATM adapter buffer size succesfully changed; REBOOT for change to have an effect Error: an alternate MAC address must be specified before enabling it. ATM alternate address succesfully enabled/disabled; REBOOT for change to have an effect ATM alternate mac address succesfully changed; REBOOT for change to have an effect Starting ATM Signalling Daemon Updating TCP/UDP parameters in /etc/rc.net to semi-optimum values for high performance ATM networks. Networks with lower bandwidth will have different optimum settings. This change could affect performance on installed, lower bandwidth networks; eg. token ring, ethernet, etc. See /etc/rc.net. IBM PCI 25MBPS ATM Adapter (14105300)Adapter PCI Bus I/O Starting AddressAdapter PCI Bus Interrupt LevelMinimum Adapter pre-allocated Transmit DescriptorsMinimum Adapter Pre-DMA-mapped Receive MbufsHigh-Priority PVC Peak Segmentation RateEnable ALTERNATE ATM MAC address ALTERNATE ATM MAC address (12 hex digits)Minimum Guaranteed VCs SupportedMaximum Number of VCs NeededAdapter ISA Bus I/O Starting AddressAdapter ISA Bus Interrupt LevelAdapter ISA Bus DMA Request LevelIBM ISA 25MBPS ATM Adapter (IBM0020)Enable OAM F4 Flow ControlMinimum pre-allocated Transmit DescriptorsMinimum 4K pre-mapped receive buffersUser High-Priority PVCs Peak Rate(Kbps)ISA Bus Master Request LevelISA Bus Interrupt Request LevelEnable OAM F4 Flow Controlthe minimum number of transmit descriptors the device driver should allocate at initilization. the minimum number of 4K bytes receive mbufs the driver should allocate and pre-map for DMA at initilization. the peak rate, specified in Kbps, for all dedicated (non-best-effort) Permanent Virtual Connections(PVCs). Specifies which DMA request lines the adapter should use during bus master cycles. Specifies which IRQ lines the adapter should indicate an interrupt. Allow the hardware to transmit and receive OAM F4 flow control cells.