ùISO8859-1*<$gŒ¥¬³ ºÅ Ê Õ ä µï ¥ ­µ ¾ÈÑ1Ù [#*1ªÜñ!=Rh |‰˜ Ÿ­ !À !âT 1aŸ“ 13ezŽ!Ÿ gÁ+ ) U j! ~   ¨ ² º à ΠÙõ èDisplay Multipath I/O Device ConfigurationDisplays the status for MPIO devicesSoftware Error!!ADAPTERDEVICESTATUSPARENTCONNECTIONPATHRESPONDINGNOT RESPONDINGnot testedRESPONDING - the connection is GOOD, this mpio device responds to the I/O through this connection NOT RESPONDING - PATH to the device is not operational. Run Diagnostics. not tested - this mpio device is currently NOT enabled/disabledmissingdefineddetectedavailabledisabledenabledDISPLAY MULTIPATH I/O (MPIO) DEVICE CONFIGURATIONFinding MPIO devices...The `lspath` command cannot be found on this system. Please install appropriate packages.No MPIO device can be found on this sytem.DISPLAY MULTIPATH I/O (MPIO) DEVICE CONFIGURATIONDisplay MPIO devicesDisplay MPIO adaptersSpecify MPIO deviceDisplay Hierarchy of MPIO devicesDISPLAY MPIO DEVICESDISPLAY MPIO ADAPTERSSPECIFY MPIO DEVICELogical nameLogical parentStatusPath responseMPIO DEVICE STATUSDISPLAY HIERARCHY OF MPIO DEVICESDISPLAY HIERARCHY OF MPIO DEVICESStatus: -------------------------------------------------------------------------------- Display Multipath I/O (MPIO) Device ConfigurationDisplays Multipath I/O (MPIO) Devices, Paths and Hierarchy. This Service Aid is capable of testing the state of a path to determine if the path is responding.DISPLAY MULTIPATH I/O (MPIO) DEVICE CONFIGURATIONDISPLAY MPIO DEVICESDISPLAY MPIO PARENTMPIO PATH STATUSDISPLAY HIERARCHY OF MPIO DEVICESThe columns are shown in the following order: Parent, Device, Path ID, Path Status, and Path ResponseNo MPIO devices can be found on this systemDisplay MPIO devicesDisplay MPIO parentDisplay Hierarchy of MPIO devicesdefinedavailablemissingdetectedNOT testedRESPONDINGNOT respondingThe last column, Path Response, describes the states of the path which can be one of the following: RESPONDING - The connection is GOOD, this MPIO device responds to the I/O through this path. NOT responding - The device is not responding to any I/O through this path. NOT tested - This MPIO device is currently NOT enabled (disabled) This Service Aid is not intended to test the device. For further testing on the device: 1. If this device is supported by IBM, please refer to the 'Reference Guide' for the particular subsystem or the 'Service Guide' for the system. 2. If this is an OEM device not supported by IBM, please contact the manufacturer of this device for support.