ùISO8859-1"&D=k©Bªí ˆ!£ Å ä ô ý  ",<CÂ] Ò  s€‚=ƒÁ/Âò×óËÌ Í!Dæ"Ñ +` ýÝ ^DIAGNOSTIC PACKAGE UTILITY SERVICE AIDREMOVE.........the diskette, if any, from the diskette drive.INSERT.........a blank formatted diskette into the diskette drive.When finished, press Enter.Please stand by.This menu is used to create a console configuration file that allows a terminal attached to any RS232 or RS422 adapter to be selected as a console device. The default device is a RS232 tty attached to the first standard serial port(S1). If the default tty console selection is desired, then press COMMIT to continue. Otherwise, modify the fields as required, then press COMMIT to continue.MODIFY CONSOLE CONFIGURATION FILEModify the fields as required.Connection typeLocationSpeed (baud rate)Bits per characterStop bitsFlow disciplineParityTERM environment variableThis menu is used to create a console configuration file that allows the refresh rate used by the standalone diagnostic package to be set to the refresh rate used by the graphics display. If the graphics display's refresh rate is 77 Hz, then set the refresh rate below to 77. The default refresh rate is set to 60 Hz. If the default refresh rate is desired then press COMMIT to continue. Else modify the field below, then press COMMIT to continue.The Configuration Diskette was not created. Since the default selections were taken, the Configuration Diskette is not needed.The Configuration Diskette was written successfully. To use this diskette when running diagnostics from the standalone diagnostic package, insert the diskette into the diskette drive before IPL'ing the system.Refresh rateCreate a Standalone Diagnostic Package Configuration DisketteMove the cursor to selection, then press enter.A %s MB diskette drive is required to run this service aid. This service aid could not find the device. If this device is present on the system, run diagnostics to determine the problem. To continue, press Enter.Press Enter to continue.An error occurred while trying to create the configuration diskette.A diskette drive is required to run this service aid. This service aid could not find the device. If this device is present on the system, run diagnostics to determine the problem. To continue, press Enter.This menu allows a non-default async tty to be used as the console during standalone diagnostics from removeable media. The default tty console is a RS232 tty attached to serial port 1 configured at 9600 baud. Values are selectable by either using the 'List' key, or by typing in the desired value. The Location, Speed, and Terminal Type must be typed in. Possible values for each are: Location: 00-00-S1-00 00-00-S2-00 or other location value. Speed: 150,300,600,1200,2400,4800,9600, etc. Terminal Type: ibm3151, ibm3161, ibm3163, etc. Select the value that best matches your configuration.Changing the default refresh rate of a Low Function Terminal (LFT) The Diagnostic stand alone package uses the default refresh rate of 60 Hz for an LFT. To change the default refresh rate to 77 Hz, a configuration diskette can be created using this Service Aid. If you choose to create a configuration diskette for use by Diagnostics, then select the default refresh rate by using the 'List' key. If there are no changes or you are done making changes, press the commit key.