ùISO8859-1\`cirobâ¶E %ü"?Wq‹§'à -ë + 4E ;z <¶ ó-CToŠ ™ Œ¶zC» ¾ó zB nr ±^ $ž ƒ "YESNOfiberRJ-45The next test requires a wrap plug from the following list for the %1$s connector: %2$s. Do you have a wrap plug?UNPLUG.........the network cable, if attached, from the connector on the ATM adapter. PLUG...........the wrap plug into the ATM adapter connector. Use a wrap plug from the following list: %1$s. ENSURE.........the wrap plug is properly seated to prevent receiving an invalid SRN.UNPLUG.........the wrap plug from the connector on the ATM adapter. PLUG...........the network cable, if removed, into the connector on the ATM adapter.Hardware failure opening the adapter.Adapter memory test failure.Interrupt test failure.Adapter checksum failure.Adapter DMA test failure.Internal wrap test failure.External wrap test failure.Enhanced Error Handling failure on bus.Enhanced Error Handling failure on Eads chip.Enhanced Error Handling failure on adapter.Enhanced Error Handling failure opening the adapter.Error Log Analysis indicates an I/O failure on the adapter.Error Log analysis indicates an unrecovered interrupt error.Opening deviceRunning memory testRunning interrupt testRunning checksum testRunning DMA testRunning internal wrap testRunning external wrap testClosing deviceEnhanced Error Handling Test%1$06.6lx ADDITIONAL INFORMATION FOR (%2$s) IN LOCATION %3$s Diagnostics did not detect a problem with your hardware. However, Error Log Analysis has detected a configuration error. This error can be caused by a system configuration problem or insufficient system resources. If you are experiencing problems with your ATM adapter, verify the configuration and availability of system resources.%1$06.6lx ADDITIONAL INFORMATION FOR (%2$s) IN LOCATION %3$s Error Log Analysis has detected a configuration error. This error can be caused by a system configuration problem, insufficient system resources, or a hardware adapter problem. Run diagnostics on the ATM adapter. If no problem is found, verify the configuration of the adapter and availability of system resources.%1$06.6lx ADDITIONAL INFORMATION FOR (%2$s) IN LOCATION %3$s Error Log Analysis has detected multiple communication errors. These errors can be caused by: %4$s %5$s %6$s%1$06.6lx ADDITIONAL INFORMATION FOR (%2$s) IN LOCATION %3$s Diagnostics did not detect a problem with your hardware. However, Error Log Analysis has detected multiple communication errors. These errors can be caused by: %4$s %5$s- Cable loose or defective: Check cable and connections.- Attached device: Verify attached device is powered up, configured, and functioning properly.- System I/O Bus Overloaded: Ensure there are sufficient system resources.- System Hardware: Run diagnostics on the ATM adapter. NOTE: The adapter must be taken out of use before diagnostics can be run.