ùISO8859-1J#An$°iÕR?z’n ·| ’4 {Ç TC ,˜2ÅIø/Bhr Ûàá¥ÂY hB Â7 X =+ –   • Ä  ZINSTALL MICROCODE %1$s %2$sInstallation of the microcode has completed successfully on %1$s and %2$s.Installation of the microcode has completed successfully on %1$s.The current microcode level is %1$s.Please run diagnostics on the resources %1$s and %2$s to ensure that the adapter is functioning properly.Please run diagnostics on %1$s to ensure that the adapter is functioning properly.However, an error was detected while unconfiguring %1$s and %2$s. Unable to restore the resources to their original state.However, an error was detected while unconfiguring %1$s. Unable to restore the resource to its original state.However, Configuration Database was not updated. Please run rmdev -l %1$s -R rmdev -l %2$s -R followed by cfgmgr -l %3$s cfgmgr -l %4$s to get the Configuration Database updated.However, Configuration Database was not updated for %1$s. Please run rmdev -l %2$s -R cfgmgr -l %3$s to get the Configuration Database updated.Until this is done, neither lscfg nor the Display Microcode diagnostic task will reflect the correct microcode information.Installation of the microcode has completed successfully on %1$s but failed on %2$s.The current microcode level on %1$s is %2$s.The current microcode level on %1$s is still %2$s.Please run diagnostics on %1$s to ensure that it is functioning properly.Run diagnostics on %1$s to isolate the problem.If there are no problems with the adapter, running diagnostics on %1$s may update the microcode on %2$s. *** NOTICE *** NOTICE *** NOTICE *** %1$s represents a port on a dual-port fibre channel adapter. To update microcode on this adapter, microcode needs to be installed on both %2$s and %3$s. Selecting either %4$s or %5$s installs microcode on both ports.%1$s represents a port on a dual-port fibre channel adapter. The other port of this adapter is currently not defined as a resource in the system. When this port is configured, it will also have the newly installed microcode.The microcode installation occurs while the resources are available for use. It is recommended that the installation be scheduled during non-peak production periods.If any drives are attached to this adapter, make sure that a current backup is available.Use Enter to continue installation. Use F3 to cancel installation.%1$s represents a port on the dual-port fibre channel adapter. To update microcode on this adapter, microcode needs to be installed on both ports. The other port of the adapter is not available for microcode installation. Please make sure that both ports of the adapter are configured and run this task again.A software error occurred. Contact the service support structure for further assistance. *** NOTICE *** NOTICE *** NOTICE *** The system configuration indicates that there are client processes using this adapter. Microcode Download can not proceed under these circumstances. *** NOTICE *** NOTICE *** NOTICE *** %1$s represents a port on a multi-port fibre channel adapter. To update microcode on this adapter, microcode needs to be installed on both %2$s and %3$s. Selecting either %4$s or %5$s installs microcode on both ports.