ùISO8859-1´'¼ä;W$p &• #¼ à ÷ &; R\'q™´Ïæ$ö2$In)ˆ<²gïBW>šBÙ1.N ˜} é k % l L ’B ßL "H o^ ¸3 ¤ K= ð& .@ U6 –xmtopasChange/Show xmtopas configuration file Maximum number of connections Supply data to remote CECSupply data to remote ClusterEnable SNMP Data collectionEnable xmtopas recordingList of only hosts (Comma separated)List of always hosts (Comma Separated)List of suppliers (Comma Separated)Enable CEC AggregationAvailable Memory in GBUnvailable Memory in GBAvailable ProcessorsUnavailable ProcessorsPool SizeNumber of PartitionsReconfig secs to check HMC ConfiguratioEnable Cluster AggregationCluster Configuration fileEnable/Refresh xmtopasDisable xmtopasFailed to add xmtopas entry to inetdFailed to kill xmtopasxmtopas is not runningFailed to delete xmtopas inetd entryNot Supported inside WPARThis menu leads to xmtopas Configuration This menu helps to configure xmtopas using xmtopas.res file.Specify the configurations requested. This will be used by xmtopas to configure itself while it starts.Specify the maximum number of connections that need to be allowed.This helps to enable/disable the supply of data to remote CEC.This helps to enable/disable the supply of data to remote cluster.This helps to enable/disable SNMP data collectionThis helps to enable/disable xmtopas recordingSpecify the hostnames/ipaddress of the hosts which are allowed to access data from xmtopas daemon. The other hosts are restricted to access this daemon.Specify the hostnames/ipaddress of the hosts which are allowed to access data always from xmtopas daemon even the maximum connections limit exceeds. only hosts should also contain the hosts specified in this list or only either one of the options that is only hosts option/always option should be used.The idea is to make sure that persons who need to do remote monitoring from their hosts can indeed get through, even if the number of active data consumers exceeds the limit established. Specify the suppliers . This should have the full path name of the executable dynamic data-supplier programThis helps to enable CEC aggregationSpecify the total amount of memory allocated to all partitions, in GigabytesSpecify the total amount of memory unallocated from the HMC, in GBSpecify the total number of physical processors allocated for all partitionsSpecify the total number of physical processors unallocated from the HMCSpecify the defined Pool Size required if HMC Processor Utilization Authority restricts accessSpecify the number of partitions defined on the HMCSpecify the number of seconds between checking for HMC configuration changes. Valid values are 30, 60, 90, 120, 180, 240,and 300 seconds. The default is 300 secondsThis helps to enable Cluster aggregation based on user inputsSpecify the cluster configuration fileThis menu helps to add/activate/refresh inetd entry for xmtopas.This menu helps to deactivate inetd entry for xmtopas.