ùISO8859-1)´È"Ûþ%;<P " ° Ç × 1í<Zo,„± Î#ï%*9d‚5›Ñéú ! ."$O#*t$Ÿ% »&)Ü'-( 4) U*!v+˜ ²¹ ÈÓ*âË ?Ù= SCSI I/O ControllerBus memory addressAddress of bus memory used for DMABus interrupt levelInterrupt priorityDMA arbitration levelAdapter card SCSI IDNumber of COMMANDS per device which may be queued to adapterName of adapter code download fileBATTERY backed adapterBus I/O addressDMA bus memory LENGTHPERCENTAGE of bus memory DMA area for target modeEnable TARGET MODE interfaceTarget Mode interface enabledExternal bus SCSI IDInternal bus SCSI IDMaximum synchronous data transfer rate (mHz)Standard SCSI I/O ControllerWide SCSI I/O Controller AdapterSCSI I/O Controller Protocol DeviceNumber of target mode RECEIVE BUFFERSAddress of bus memory used for target modeTarget mode bus memory lengthWide SCSI I/O ControllerMaximum number of commands to queue to adapter driverProtocol device SCSI IDWide bus enabledExternal bus wide enabledInternal bus wide enabledSCSI bus transceiver alternativeNegotiate after SCSI check conditionNumber of DMA bursts per PCI bus ownershipPCI-SCSI I/O Processor typeWide/Fast-20 SCSI I/O ControllerUltra speed on SE bus with external cableBus mode limiting wide transfer with 2 cablesWide/Ultra-2 SCSI I/O ControllerWide/Ultra-3 SCSI I/O ControllerParallel Protocol Request enabledDomain Validation enabledyes,noenable,disabletrue,falseLVD/SE,SE,noneThis attribute is used to enable Parallel Protocol Request messages (PPR) used during SCSI data transfer negotiation. Enabling PPR requires that the 'wide' attribute also be set. Note that Ultra-3 (Ultra160) data transfers can only be negotiated using PPR. The attribute is enabled by default. This attribute is used to enable Domain Validation (DV). DV is a software method used to determine if negotiated data transfer speeds are supported by the medium. The attribute is enabled by default. Changing enable_PPR to 'yes' requires enable_wide to be 'yes'. Changing enable_wide to 'no' requires enable_PPR to be 'no'.